Skip to content
Knowledge Shared
16

Blog #16

Back pain on the bike: how to ride longer and more comfortably

3 min read

The first hour feels fine. By hour two, a tight, achy band has settled across your lower back, and by the time you hop off and start your brick run you're standing up like a question mark. Lower back pain is one of the most common complaints we see in cyclists, from first-time sprint athletes through to seasoned long-course racers.

What's going on?

Based on the evidence, most cycling-related back pain is non-specific, meaning it isn't caused by a single damaged structure but by sustained load on the tissues of the lumbar spine (lower back). When you ride, your spine is held in a flexed (rounded) position for long periods while the back extensor muscles work continuously to support your upper body. Think of holding a shopping bag at arm's length: it's easy for a minute and exhausting after an hour.

The most common contributors include tight hip flexors from long periods of sitting, limited hamstring flexibility, low trunk endurance and an aggressive aero position. Bike set-up also plays a role. A saddle that is too high can cause your pelvis to rock, and a reach that is too long overloads the back and shoulders.

If you're dealing with back pain on the bike, here are a few things that you can try.

Get a bike fit

Our first goal is to keep you riding comfortably, and a professional bike fit is often the best place to start. Even small changes to saddle height, reach or cleat position can make a big difference to how your back tolerates long rides.

Build trunk endurance

A common sign we see is a trunk that fatigues well before the legs do. The back muscles need endurance more than peak strength, so exercises such as bird dogs, dead bugs and side planks are a good starting point. Begin with 2–4 sets of 20–30 second holds with good control.

Strengthen the posterior chain (glutes and hamstrings)

Strong glutes and hamstrings allow the hips to take more of the load off the lower back. Performing exercises such as glute bridges and hip hinges, including RDLs, is a good starting point. Begin with 2–4 sets of 8–12 reps with a slow and controlled tempo.

Open up the hips

Long hours sitting at a desk and then on the bike can leave the hip flexors tight. Gentle hip flexor stretches, holding for 60–90 seconds each side after rides, can help.

Move during long rides

Shift your position, stand briefly on climbs or flat sections, and relax your grip and shoulders every 15–20 minutes. Small changes in position spread the load across different tissues.

Ease into the aero position

If you are new to the aero bars or at the start of a block, build up the time you spend aero gradually over several weeks, rather than doing a long ride in the position straight away.

When to get it checked

Cycling-related back pain can often be managed with the steps above. However, it is important to book an assessment if you find that your pain isn't improving after a couple of weeks or it starts affecting your sleep or daily activities. Seek prompt medical attention if you notice numbness or tingling in the saddle area, difficulty controlling your bladder or bowels, progressive weakness in a leg, or pain that travels below the knee.

The takeaway

Back pain on the bike is rarely about a weak back alone. It usually comes from a combination of bike set-up, hip mobility and trunk endurance, and each of those can be improved.

Not sure which piece is your weak link? Book an assessment and we can work out what's driving it.

Who we have worked with

  • Rugby Australia
  • Australia Sevens
  • Junior Wallabies
  • NSW Rugby League
  • Wallaroos
  • NSW Swifts
  • NSW Sky Blues
  • South Sydney Rabbitohs
  • Derby County Football Club
  • Sydney FC
  • Western Sydney Wanderers
  • Canterbury-Bankstown Bulldogs
  • Eastwood Rugby Club
  • Wests Tigers